Sleek, built-in sofa from Vuren Timmer Panel, by Robert

Description

Built-in sofa in the bay window in the living room, a real 'windowsill'.

• Backrest same as windowsill.


• Power supply for tablet/telephone on right.


• Radiator grille above radiator, between sofa backrest and windowsill.


• Wooden frame with fabric covering underneath.

Work description: how did you realize your project

Taking measurements of the living room. A clearance of 5 mm has been taken into account in the width, in order to correct the out-of-squareness of the walls.

Wood ordered from OPMAATZAGEN.nl. Ordered some parts larger than necessary and later sawed various parts of the backrest/electricity supply at home.

• Cornered edges on the visible side of the sofa (armrest, backrest, front of seating area) beveled at the top/front.


• Cut a hole for electricity supply with a 10.0 cm hole saw.

li>Assemble the bench with screws 5.0 x 80, pre-drilled with 4 mm (front part of wood) or 3 mm (rear part of wood) to prevent splitting/cracking.

• Test fitting or everything fits. Everything fit.


• Sofa taken apart. Degrease, prime 2 times, topcoat 3 times.


• Heating grid made of slats 27 x 18, frame made.


• Fabric stretched and stapled to the bottom.

Final size: What are the outside dimensions?

Wide part:
270.0 cm wide
60.0 cm deep (56.0 cm + 4.0 cm backrest)

'Corner' section:
58.0 cm wide
60.0 cm deep (56.0 cm + 4.0 cm backrest)

Seat height: 42.5 cm ( hairpin legs 30.5, sofa 4.0 cm wood, seat cushion 8.0 cm)

Backrest height: 19.4 cm